UnsupportedShow Details
Unknown
gamemoderun %command%
Juego a 2k, con graficos en Alto y con la sincronizacion vertical activada a 60 fps, y es muy estable.
Runs without an issue
No tinkering required, just install and play
Turn down graphics a bit and it should work fine
Had to play on low to medium settings as frame rate would be around 40FPS or lower otherwise. Wouldn't expect that with my system
none
On some occasions, the game would play normally for some 15-20 minutes, but on others it would crash after some minutes of gameplay. So far it looks to be random, but will check in more detail.
Some decrease in frames per second, but playable
Some lags on wide parts of the open world map. Don't know if the game is badly optimized or if this is something proton related
Downgraded to 580p
Even at native resolution
Low resolution makes everything blob together
Native resolution holds at about 50-55 FPS during missions, can drop as regularly low as 45 FPS, especially during off mission/open world hub exploration. Turning FSR on with max sharpness at 928 x 580p is the sweet spot for being not too blurry, but sometimes drops at 55 FPS.
40hz vsync, low settings = around 15w power consumption
Can hold 60 fps on low but there are frequent drops below 50fps
gamemoderun %command% +fps_max 60
Constant stuttering, freezing, fps ranges from 10 to 25
Freezing is so bad, the game eventually crashes
Both Exprerimental and GE Proton versions yield unplayable mess. Played through the prologue just fine with 20-25 fps, but after that the game is freezing and stuttering so much that the experience turned from okay to unplayable slideshow, that will eventually crash.
Game runs very well, without graphical glitches or performance degradation.
Never played it on Windows but looks like game runs as native.
Black screen on start up
stuck at black windows after the game launches. not able to bypass by pressing Esc or Enter key
Sniper Ghost Warrior 3 runs fine on Linux with minor tinkering possibly required. Tested on both Proton Experimental and ProtonGE.
It sometimes gives issues with alt-tabbing and the Steam overlay.
The game has some performance issues when switching between resolutions.
After Proton 3.7-8, the performance degrades. I have NVIDIA GTX 1650Ti and the game works from that GPU, even if Steam says otherwise.
Game has launched successfully without any tweak at the first time but I had to use Proton 3.7-8 to make it work for the rest of times.
Played over 66 hours. Downloaded and installed ok with no extra steps and runs very well.
You get a black screen on start up, click on your space bar and the game continues.
it runs very well.
Sometimes drops frames
Sometimes crashes. I tried to disable fire and shot animation, in menu option, and it works. I think the problem was my graphic card (GTX970 4GB)
Très bonne jouabilité sous Linux / Very good gameplay on Linux
2 ou 3 freezes de pilote graphique, mais j'ai fini le jeu + les DLC / 2 or 3 GPU freezes, but I've finished the game + DLCs :-)
Avec Cinnamon, il fallait parfois utiliser Alt+Tab au lancement pour avoir le mode plein-écran / With Cinnamon, using Alt+Tab was sometime needed to get fullscreen after launch. Dur à dire si les quelques freezes graphiques étaient spécifiques à Proton+Linux ou juste un bug du pilote NVIDIA / hard to say if the few GPU freezes were due to Proton+Linux or just a NVIDIA driver bug...
ne dépasse pas 20 fps en 1080 sur mon pc
Problème de fps
It works quite well except for having to reset your cursor to the middle of the screen every so often.
Every few minutes the mouse input would stutter and would need a few seconds to catch back up. Additionally, the game doesn't grab the cursor properly, as (most of the time) when I look far to the left it stops at a certain point and I have to hit escape and move the cursor back to the middle of the screen to look further. Same with the other directions.
Not sure if it's related to proton or not but after playing for about 5 hours straight the frame rate dropped to way below 60 fps. Before that point it was consistently above 60 fps.
The game crashes when selecting quit from the main menu, freezing the screen and requiring a reboot (I haven't tried killing it with a process manager because it gets stuck behind the game's window, so I can't see it and select the right process), and I've experienced a few (2-3) crashes of similar nature while playing.
Unknown(> 10 hours with Proton)It works at 40-50 fps with high level setting. sometimes it freeze and crash.
Unknown(> 10 hours with Proton)
Don't expect to have solid 60 FPS all the time. The game is extremely GPU demanding, even with the video settings on Low.
There is some screen tearing, judder and lag, but it is mostly playable. You need to add the teejee2008 PPA and UKUU software package to install Linux kernel 4.20.0 64 bit. Then, you need to add the X-Swat Updates PPA and install the Vulkan drivers and restart your gaming desktop PC. Run Steam, install Sniper: Ghost Warrior 3 and play it. My ASUS ROG STRIX GL702ZC gaming notebook PC runs it just fine using the stable Padoka PPA, Vulkan drivers and Linux kernel version 4.20.0 64 bit as well.
Unknown(2+ hours with Proton)Work well without problem
Unknown(2+ hours with Proton)Unknownblack screen on start
UnknownUnknownPlayed first missions, runs well without any issues
Unknown
