LinuxEnthusiest
Published
None
Using OS screenshot (i.e. printscreen) minimizes game.
Trying proton several versions game will not launch. Only native worked for me. On my hardware around 150fps in most firefights with bots and smoke. Depending on the map and where you stand and face frames dip to around 135-145 (1440p) like all reviews in the same sopts have been seeing. Likely a map/model issue (i.e. dust2 T start free cam on down hill face the CT spawn 135-145fps no matter how low the settings, face to the left toward site b and hit 165 w/ vsync 200+ without sync). Running around non firefight is around 180fps avg. Micro stutter here and there but does not negatively affect gameplay. Still perfectly playable. These results with default detected high setting and adding FSR ultra quality, same results/numbers.
Will not launch uplay. In fact, I don't think it even trys to launch it or install it. It just says it's not there.
Div 2 works perfectly fine. Play Div 2 instead. Breakpoint will not start. No battleye folder inside breakpoint. Installed last night 10/10/2023. Tried multiple proton versions.
MANGOHUD=1 PROTON_ENABLE_NVAPI=1 gamemoderun %command%
Buttery smoothness
Using up to date proton designed for dx11/12 games is ok but, there is performance issue is SOME areas, not all, with my hardware. Switching to 6.3.8 fixed all of it AND can use mangohud/vkbasalt; mangohud/vkbasalt would not load without using 6.3.8.
Maybe? IF you have the highest end, expensive HW available to sustain 60+ FPS without FSR. Game will not load in game after enabling.
gamemoderun %command% -d3d11
Default sensitivity was WAAAAAAYYYYYYYYY too sensitive. Barely touching mouse would 360 view so fast I couldn't move properly.
Technically unsure. As mentioned, I cannot load into the game after 1 and only 1 successful login anymore to verify save game state.
45~55fps when doing things (only got to build in tut before crashing trying to enable fsr)
Enable fsr results in perma crashing on startup and unable to change settings afterward. Can't load into the game to do so.
Enable FSR perma broke game loading. No longer loads into game. Performance is bad without FSR. I have games that perform and look better without FSR.
Game did 'run' after initial install and load in. However, performance was bad (around 45 fps) and this was just me in the tutorial by myself. I imagine it would tank further, at least a little bit, with more people and enemies and stuff going on. Enabling FSR perma broke the game. It just crashes trying to load in now so I can't event get to the settings to turn off FSR and no 'settings' file I could see and don't think I'm going to waste my time looking. I have games that use and run just fine on linux (both fsr AND dlss). Most of my games don't even need it as they run typically around 90+ fps @4K on high.
I also tried other protons GE9-5, Experimental, 9.0-2. Everything results in Assertion failed error.
none
Use 8.0-2 and run. vkbasalt works fine. Mangohud or other commands will not launch game.
none
Ubi barfed up the launcher with Steam. 8.0-2 crashes. Experimental works. Be. Patient. It...takes..a..while...to...load..but, it will eventually load.
Make a cup of coffee or something and should be loaded or close when you get back.
